Support for Model: 110/60ATS-3/B

Winco Automatic Transfer Switch

Share your thoughts!

Let us know what you think...

What others are saying

  1. Steve Emspak

    Steve Emspak

    Generator starts manually however when I try to start it by selecting Run on the ATS I get noting. This is a current problem as the system has been working until recently. What could cause that?

    Upvote if this was helpful (0) Downvote if this was not helpful (0) Flag for removal

    Something wrong with this post? Thanks for letting us know. If you can point us in the right direction...

    • Dale Riebel

      Admin Dale Riebel

      Steve, it could be as simple as a bad toggle switch on the transfer switch. Please call our Service Department @ 507-357-6831 for further guidance.

      Upvote if this was helpful (0) Downvote if this was not helpful (0) Flag for removal

      Something wrong with this post? Thanks for letting us know. If you can point us in the right direction...

  2. HHPA

    HHPA

    My customer had a similar problem on March 22, 2018. The gen set would not switch on from the transfer panel. Both the start stop relay (SSR) and the select switch (start/disable/automatic) on the transfer panel were intermittent.

    John

    Upvote if this was helpful (0) Downvote if this was not helpful (0) Flag for removal

    Something wrong with this post? Thanks for letting us know. If you can point us in the right direction...

  3. John 423-842-3879

    John 423-842-3879

    my units ser no 1729098. When I had the unit installed the electrification informed me he could wire it up for auto. stand by service. I had always been able to start it from the garage and place it on line.A couple of years ago I could not start it remotely (garage) I had to go out side and start it from inside the panel . I contacted a company down in Jasper Ga. PSU and they sent a tech. a sharp kid, he stated that there was a problem in the Control assy not allowing me to start it remotely (garage )
    so what ever the problem is, its in the engine control assy. he was in a hurry and I didn’t write what he said and he left. my question is: are there any parts still available through you ???
    But we need this thing to be either automatic or at least be able to start it from the garage, HELP

    Upvote if this was helpful (0) Downvote if this was not helpful (0) Flag for removal

    Something wrong with this post? Thanks for letting us know. If you can point us in the right direction...

    • Dale Riebel

      Admin Dale Riebel

      Hi John, Yes parts are still available for that model transfer switch. It could be a defective toggle switch on the transfer switch that is keeping it from operating remotely. You can call our Service Department @ 507-357-6831 and we will gladly troubleshoot the issue with you.

      Upvote if this was helpful (0) Downvote if this was not helpful (0) Flag for removal

      Something wrong with this post? Thanks for letting us know. If you can point us in the right direction...

    • Doug taylor

      This Transfer switch is DOA. It will not transfer during an outage. I will not toggle to run or exercise

      Upvote if this was helpful (0) Downvote if this was not helpful (0) Flag for removal

      Something wrong with this post? Thanks for letting us know. If you can point us in the right direction...

    • Dale Riebel

      Dale Riebel

      Doug, please contact our Technical Support Department at 507-357-8334 or [email protected].

      Upvote if this was helpful (0) Downvote if this was not helpful (0) Flag for removal

      Something wrong with this post? Thanks for letting us know. If you can point us in the right direction...

  4. Question

    Dave Bryson

    My ats 110/60 serial # 4490 F00 needs to be replaced due to multiple issues. Tech says parts would cost more than replacement. Where can I get a replacement unit?

    Upvote if this was helpful (0) Downvote if this was not helpful (0) Flag for removal

    Something wrong with this post? Thanks for letting us know. If you can point us in the right direction...

    • Dale Riebel

      Dale Riebel

      Dave, you can email me and I’ll provide you a quote for a replacement transfer switch, [email protected]. Otherwise you can use our Dealer Locator and work with a local Winco Dealer for that product.

      Upvote if this was helpful (0) Downvote if this was not helpful (0) Flag for removal

      Something wrong with this post? Thanks for letting us know. If you can point us in the right direction...

  5. Question

    Gerardo Negron

    Its this model is Rain Tigth (NEMA Specifications)?

    Upvote if this was helpful (0) Downvote if this was not helpful (0) Flag for removal

    Something wrong with this post? Thanks for letting us know. If you can point us in the right direction...

  6. Question

    Rich

    My ATS has a consistent low humming. Why is is humming and If I need to replace any parts, are they still available?

    Upvote if this was helpful (0) Downvote if this was not helpful (0) Flag for removal

    Something wrong with this post? Thanks for letting us know. If you can point us in the right direction...

    • Dale Riebel

      Dale Riebel

      Rich, please contact our Technical Support Department @ 507-357-8334 or [email protected]. The line side contactor 64585-006 is still available. That is the contactor that is humming. Parts Department: 507-357-8332.

      Upvote if this was helpful (0) Downvote if this was not helpful (0) Flag for removal

      Something wrong with this post? Thanks for letting us know. If you can point us in the right direction...

×

Login

Continue as a Guest