Step 1. Verify Exerciser is Set
| ATS MODEL | COMMAND | PASS | FAIL |
|---|---|---|---|
| WINCO | Review programming | Set | Not Set: Set program |
| ASCO165 | Check exercise light to see if it is blinking for the approximate number of days until test | Light is blinking | Light is not blinking |
| ASCO185 | Check exercise light to see if it is on | Exercise light is on | Exercise light is off: Set exerciser |
Step 2. Verify Exerciser
| ATS MODEL | COMMAND | PASS | FAIL |
|---|---|---|---|
| WINCO | Set exerciser to set in near future. Verify 120V to the relay is present. Record hours or starts (if equipped) Return after test interval to verify | Generator running in test cycles | Generator has not tested |
| ASCO165 | This switch will automatically set it to exercise in 14 days. It is a long process. Record hours or starts (if equipped) Return after test interval to verify | Generator running in test cycles | Generator has not tested |
| ASCO185 | Set exerciser Record hours or starts (if equipped) Return after test interval to verify | When you start the exerciser, the generator automatically goes into test mode. | Generator has not tested |
Step 3. Exerciser doesn’t transfer load to generator
| ATS MODEL | COMMAND | PASS | FAIL |
|---|---|---|---|
| WINCO ASCO165 | Not applicable | ||
| ASCO185 | Verify board setting | Dip Switch S1 actuator 8 is in the up position. If load still does not transfer start Will not Transfer troubleshooting steps using the exercise under load circuit | Set dip switch and retest |
Can’t set exercise program in my unit. Display is full of odd characters –
5 – 6 days are selected
timer is wrong
Please advise —
Clif Scorso